PREPARATIONS
c3_sf12.html
3
pages/c3_sf12_ss1.html
pages/c4_sf1.html
RcButton-RECEIVER
RcButton-z
PREPARATIONS
Connecting to the MusicCast network
Adding
the unit to the MusicCast network
1
MusicCast Link Power Interlock
11Connecting to the MusicCast network
Adding
the unit to the MusicCast network
Follow
the procedure below to add the unit to the MusicCast network. You
can also configure the unit’s wireless settings at once.
- The
SSID and security key for your network will be needed.
- If
your router supports multiple SSID’s (network names), connect the
mobile device to the first access point (“SSID 1”, etc.).
- Press RECEIVER z to
turn on the unit.
- Tap
the “MusicCast CONTROLLER” application icon on your mobile device and tap
“Setup”.
If you
have already connected other MusicCast compatible devices to the
network, tap “Settings” and then “Add New Device”.
- Operate
the “MusicCast CONTROLLER” application following the on screen instructions,
then hold down CONNECT on the front panel of the unit for 5 seconds.
- Operate
the “MusicCast CONTROLLER” application following the onscreen instructions
to set up the network.
- Operate
the “MusicCast CONTROLLER” application to playback.
- AirPlay
and DSD audio cannot be delivered.
- When
Pure Direct is enabled, input sources other than the network sources
and USB cannot be delivered.
- If
you configure the unit’s wireless settings with this method, the
signal strength indicator of the front display lights up when the
unit is connecting to a network (even if a wired connection is used).
- You
can interlock the power of MusicCast devices with the power of
the unit (MusicCast master). For details, see “MusicCast Link Power
Interlock” () in
the “Setup” menu.
