PREPARATIONS c3_sf10.html 3 pages/c3_sf10.html pages/c3_sf10_ss2.html RcButton-ENTER RcGroup-Cursor_keys RcGroup-Cursor_x5F_keys RcButton-ENTER RcButton-RETURN RcButton-ENTER RcGroup-Cursor_keys RcGroup-Cursor_x5F_keys RcGroup-Cursor_keys RcGroup-Cursor_x5F_keys RcButton-ENTER RcGroup-Cursor_keys RcGroup-Cursor_x5F_keys RcButton-ENTER PREPARATIONS Optimizing the speaker settings automatically (YPAO) Measuring at one listening position (single measure) 4 Error messages Warning messages Checking the measurement results YPAO Volume (YPAO Volume)

9Optimizing the speaker settings automatically (YPAO)

Measuring at one listening position (single measure)

Follow the procedure below for measurement. It takes about 3 minutes to perform the measurement.
  1. To start the measurement, use the Cursor keys to select “Measure” and press ENTER.
    The measurement will start in 10 seconds. Press ENTER again to start the measurement immediately.
    To cancel the measurement temporarily, press RETURN.
    The following screen appears on the TV when the measurement finishes.
    If any error message (such as E-1) or warning message (such as W-1) appears, see “Error messages” or “Warning messages”.
    To check the measurement results, select “Result”. For details, see “Checking the measurement results”.
  2. Use the Cursor keys to select “Save/Cancel” and press ENTER.
  3. To save the measurement results, use the Cursor keys (e/r) to select “SAVE” and press ENTER.
    The adjusted speaker settings are applied.
    To finish the measurement without saving the result, select “CANCEL”.
  4. Use the Cursor keys (e/r) to select “YES” or “NO” to enable/disable YPAO Volume and press ENTER.
    • If YPAO Volume is enabled, the high- and low-frequency levels are automatically adjusted according to the volume so that you can enjoy natural sounds even at low volume.
    • You can also enable/disable YPAO Volume in “YPAO Volume” () in the “Option” menu.
  5. Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
Caution
The YPAO microphone is sensitive to heat, so should not be placed anywhere where it could be exposed to direct sunlight or high temperatures (such as on top of AV equipment).