om02screenparameters0190
On the Noise screen, you can set the Noise Generator.
Operation
- [PERFORMANCE] → [EDIT/
] → Part selection → Oscillator selection → Noise
Noise Tone (Noise Generator Tone)
Sets the frequency response for the Noise. Settings: 0–64–127
0–63: Cuts the treble
64: White noise
65–127: Cuts the bass
Out Level (Noise Generator Out Level)
Sets the volume of the Noise. Settings: 0–511
Out Level/Vel (Noise Generator Out Level Velocity Sensitivity)
Sets how the Noise volume responds to Velocity. Settings: −255–+0–+255
Connect (Noise Generator Out Select)
Sets the output destination for the Noise. Settings: Filter, Amp
Print this page