om02screenparameters0410

Registers the combination of Source and Destination in the Controller Set.

Operation
  • (When the cursor is on the parameter) Press the [CONTROL ASSIGN] button

Move the controller you wish to use for changing the parameter, or select one from the Motion Sequencer Lane or Envelope Follower.

NOTE

When you move the Super Knob but there aren’t any unused assignable knobs to proceed with the setting, an error message will appear.

When a Part parameter is selected, you can set the Assignable knobs to change the Common parameters by operating an Assignable Knob while holding down the [COMMON] button.

Print this page