Error messages from YPAO

If any error message is displayed, resolve the problem by following on-screen instructions and perform YPAO again.

[Search tag]#Q03 YPAO Error

Error message

Remedy

E-1:No Front SP

Exit YPAO, turn off the unit, and then check the speaker connections.

E-2:No Sur. SP

E-5:Noisy

Keep the room quiet and retry YPAO. If you select “PROCEED”, YPAO takes the measurement again and ignores any noise detected.

E-7:No MIC

Connect the YPAO microphone to the YPAO jack firmly and retry YPAO.

E-8:No Signal

Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.

E-9:User Cancel

Retry or exit YPAO as necessary.

E-10:Internal Err.

Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.

NOTE
  • To exit the YPAO measurement for resolving the problem, press ENTER, and select “EXIT”.
  • For the E-5 and E-9 messages only, you can proceed with the YPAO measurement. Press ENTER, and select “PROCEED”.
  • To retry the YPAO measurement from beginning, press ENTER, and select “RETRY”.