Warning messages from YPAO

If a warning message is displayed, resolve the problem by following table and perform YPAO again.

You can still apply the measurement results, however, we recommend you resolve the problem and perform YPAO again in order to use the unit with the optimal speaker settings.

[Search tag]#Q03 YPAO Warning

Warning message

Remedy

W-1:Out of Phase

Check the cable connections (+/-) of the corresponding speaker.

If the speaker is connected incorrectly:

Reconnect the speaker cable.

If the speaker is connected correctly:

Depending on the type of speakers or room environment, this message may appear even if the speakers are connected correctly. In this case, you can ignore the message. (This message is displayed to suggest confirmation to you, and it doesn't influence the playback of the unit.)

W-2:Over Distance

Place the corresponding speaker within 24 m (80 ft) of the listening position.

W-3:Level Error

Correct the cable connection or position of the corresponding speaker.

We recommend using the same speakers or speakers with specifications that are as similar as possible.

Confirm the appropriate volume to the subwoofer with a problem.

NOTE
  • On the measurement results screen, speaker indicator with “*” shows the target speaker of a warning message.
  • If multiple warnings are detected, use the left/right cursor keys to check the other warning messages.
  • Correct the cable connection or position of the speaker after turning off the unit.