Setting the send to FX BUS level

This explains how to configure the send to FX BUS levels.

  1. Open the FX screen.
  1. Drag the Send level slider.
  • Adjust the send level to FX BUS channels.
  1. Use the Pre button to switch whether to send before or after the fader.
  • Send the pre-fader signal when using on-stage floor monitors—this allows you to create a mix that is separate from the main mix.
  • Send the post-fader signal when you want to maintain the same mix balance as the main mix.
  1. Touch the ON or OFF button.
  • When turned ON, the signal is sent to the FX BUS.
Related links