Syncing the Editor and the console

When you start DM3 Editor, its settings will be different from your DM3 console's settings. For that reason, the settings of your DM3 series console and those of DM3 Editor must first be synced.

Before syncing them, you need to configure the network interface.

  1. Select SETUP → Network Interface.
  1. Select the desired network interface from the list of available items.
  1. Click OK.
  1. Click the status button in the CONNECT area.
  1. In the CONNECT screen, select the DM3 console and the direction of data syncing.
  • Only DM3 series consoles of the model you selected when you launched DM3 Editor are displayed.
  • You can use the DIRECT IP button to directly specify the IP address, instead of using an automatic search. The Unicast Level Meter button allows level meter information to be displayed even if the DM3 is on a different subnet.
  • If the maximum number (total of 3) of DM3 Editor or DM3 StageMix are already connected to a DM3 Series console, a restricted mark is displayed to the left of its IP Address. Also, even though the DM3 series console selected does not have a restricted mark displayed, when the CONNECT button is pressed, a message indicating connection was not possible may be displayed, due to the connection status of other DM3 Editor and/or DM3 StageMix.

The following sync directions are available.

DM3 → PC

DM3 series console parameter settings are copied to DM3 Editor.

DM3 ← PC

DM3 Editor parameter settings are copied to the DM3 series console.

  1. If an Administrator password has been set up for the DM3 series console, enter it.
  1. Click the CONNECT button.
  • Do not operate the DM3 series console while data is being synced.