Preparing the DAB tuning

DAB (Digital Audio Broadcasting) uses digital signals for clearer sound and more stable reception compared to analog signals. The unit can also receive DAB+ (an upgraded version of DAB) that allows for more stations using MPEG-4 HE-AAC v2 audio codec, which has a more efficient transmission method.

NOTE
  • The unit supports Band III (174 to 240 MHz) only.
  • Be sure to check the DAB coverage in your area in that not all areas are currently being covered. For a list of nationwide DAB statuses and worldwide DAB frequencies, check WorldDMB online at http://www.worlddab.org/.
  • For details on the antenna connection, see the following:

Before tuning into DAB radio stations, perform an initial scan.

  1. Press DAB to select the DAB band.
  • The following message appears on the front display if you have not performed an initial scan yet.
  1. Press ENTER to start an initial scan.
  • When the initial scan finishes, the unit automatically tunes into the first DAB radio station as stored in station order.
NOTE
  • If no DAB radio stations are found by an initial scan, the message in Step 1 appears again. Press ENTER to start an initial scan again.
  • You can check reception strength of each DAB channel label. For details, see the following:
  • To perform an initial scan again after some DAB radio stations are stored, select “Init Scan” in the “Option” menu. If you perform an initial scan again, the DAB radio stations currently registered to the preset numbers will be cleared. For details, see the following: