Error messages from YPAO

If any error message is displayed during the measurement, resolve the problem and perform YPAO again.

TV screen
Front display

Error message

Cause

Remedy

E-1:No Front SP

(E-1:NO FRNT SP)

Front speakers are not detected.

Exit YPAO, turn off the unit, and then check the speaker connections.

E-2:No Sur. SP

(E-2:NO SUR SP)

One of the surround speakers cannot be detected.

E-5:Noisy

(E-5:NOISY)

The noise is too loud.

Keep the room quiet and retry YPAO. If you select “PROCEED”, YPAO takes the measurement again and ignores any noise detected.

E-7:No MIC

(E-7:NO MIC)

The YPAO microphone has been removed.

Connect the YPAO microphone to the YPAO MIC jack firmly and retry YPAO.

E-8:No Signal

(E-8:NO SIGNAL)

The YPAO microphone cannot detect test tones.

Connect the YPAO microphone to the YPAO MIC jack firmly and retry YPAO. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.

E-9:User Cancel

(E-9:CANCEL)

The measurement has been canceled.

Retry or exit YPAO as necessary.

E-10:Internal Err.

(E-10:INTERNAL)

An internal error has occurred.

Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.

NOTE
  • Text in parentheses denotes indicators on the front display.
  • To exit the YPAO measurement for resolving the problem, use the cursor keys to select “EXIT” and press ENTER.
  • For the error messages E-5 and E-9 only, you can proceed with the current YPAO measurement. Press ENTER, and then use the cursor keys to select “PROCEED” and press ENTER.
  • To retry the YPAO measurement from beginning, press ENTER, and then use the cursor keys to select “RETRY” and press ENTER.