Error messages from YPAO

E-1:No Front SP

(E-1:NO FRNT SP)

Front speakers are not detected.

Exit YPAO, turn off the unit, and then check the speaker connections.

E-2:No Sur. SP

(E-2:NO SUR SP)

One of the surround speakers cannot be detected.

E-3:No F.PRNS SP

(E-3:NO FPR SP)

One of the presence speakers cannot be detected.

E-4:No Sur. Back SP

(E-4:NO SUR BACK SP)

One of the surround back speaker cannot be detected.

E-5:Noisy

(E-5:NOISY)

The noise is too loud.

Keep the room quiet and retry YPAO. If you select “PROCEED”, YPAO takes the measurement again and ignores any noise detected.

E-6:Check Sur.

(E-6:CHECK SUR)

Surround back speakers are connected, but no surround speakers are connected.

Surround speakers need to be connected in order to use surround back speakers. Exit YPAO, turn off the unit, and then reconnect the speakers.

E-7:No MIC

(E-7:NO MIC)

The YPAO microphone has been removed.

Connect the YPAO microphone to the YPAO MIC jack firmly and retry YPAO.

E-8:No Signal

(E-8:NO SIGNAL)

The YPAO microphone cannot detect test tones.

Connect the YPAO microphone to the YPAO MIC jack firmly and retry YPAO. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.

E-9:User Cancel

(E-9:CANCEL)

The measurement has been canceled.

Retry or exit YPAO as necessary.

E-10:Internal Err.

(E-10:INTERNAL)

An internal error has occurred.

Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.