Error messages from YPAO
If any error message is displayed, resolve the problem by following on-screen instructions and perform YPAO again.
[Search tag]#Q03 YPAO Error
Error message | Remedy |
---|---|
ERROR 1 Front speakers are not detected. | Exit YPAO, turn off the unit, and then check the speaker connections. |
ERROR 2 One of the surround speakers cannot be detected. | |
ERROR 3 One of the front presence speakers cannot be detected. | |
ERROR 4 One of the surround back speakers cannot be detected. | |
ERROR 5 The noise is too loud. | Keep the room quiet and retry YPAO. If you select “Proceed”, YPAO takes the measurement again and ignores any noise detected. |
ERROR 6 Surround back speakers are connected, but no surround speakers are connected. | Surround speakers need to be connected in order to use surround back speakers. Exit YPAO, turn off the unit, and then reconnect the speakers. |
ERROR 7 The YPAO microphone has been removed. | Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. |
ERROR 8 The YPAO microphone cannot detect test tones. | Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. |
ERROR 9 Canceled by user operation | Retry or exit YPAO as necessary. |
ERROR 10 An internal error has occurred. | Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. |
ERROR 11 One of the rear presence speakers cannot be detected. | Exit YPAO, turn off the unit, and then check the speaker connections. |
- To exit the YPAO measurement for resolving the problem, select “Quit”.
- For the ERROR 5 and ERROR 9 messages only, you can proceed with the current YPAO measurement. Select “Proceed”.
- To retry the YPAO measurement from beginning, select “Retry”.