Editing the internal parameters for OMNI OUT of the RY16-DA and control surface

This screen contains the following items.

a

Patch indication

Indicates the channel that is patched.

b

DELAY button

Switches the output delay on or off.

c

Delay time knob

Sets the delay time of the output port. If you press this knob when it is selected, the DELAY TIME popup window will appear. The delay time value is shown above the knob in millisecond units, and below the knob in the units that are selected in the DELAY SCALE popup window.

NOTE

  • If the scale is set to ms, the delay time value above the knob will not be shown.

d

PHASE button

Switches the phase of the output signal.

e

GAIN knob

Adjusts the output gain of the output port. Use the screen encoder to adjust the value. Adjust the setting in 1.0 dB units by turning the knob, or adjust the setting in 0.1 dB units by turning the knob while pressing it. The current value is shown immediately below the knob.

f

Level meter

Indicates the output level of the signal after level adjustment.

g

Tabs

Switch the display in units of eight channels.