SEND POINT page

This screen contains the following items.

a	Channel select list Enables you to select a channel.

b	ALL button Press this button to apply the selected send point to all channels simultaneously. If the send point is not selected for some channels in the column, “...” will appear.

c	PRE send point select buttons Enable you to select the send point for each channel for which PRE is turned on. These buttons correspond to the following parameters.


Button	Send Point
PRE FILTER	Immediately before the filter
PRE EQ	Immediately before the EQ
PRE DYN1	Immediately before DYNAMICS1
PRE DYN2	Immediately before DYNAMICS2
PRE FADER	Immediately before the fader

d	POST send point select buttons Enable you to select the send point for each channels for which PRE is turned off (POST). These buttons correspond to the following parameters.


Buttons	Send Point
POST FADER	Immediately after the fader
POST ON	Immediately after the [ON] key

e	FOLLOW setting buttons Enable you to select for each channel whether the signal sent to the MIX/MATRIX bus will follow the ON/FADER/DCA settings regardless of the send point. These buttons correspond to the following parameters.


Buttons	Setting
ON	FOLLOW ON
FADER	FOLLOW FADER
DCA	FOLLOW DCA

f	SEND TO [+]/[−] buttons Enable you to select the MIX/MATRIX bus channel as the signal destination for one channel at a time.

g	SEND TO [<<]/[>>] buttons Enable you to select the MIX/MATRIX bus channel as the signal destination for 12 channels at a time.