Adjusting the send to MIX/MATRIX BUS level

This explains how to configure send levels to MIX/MATRIX BUS.

  1. Open the SEND TO screen.
  1. Drag the level sliders for desired channels.
  • Adjust the send level to MIX channels.
  1. Use the Pre button to switch whether to send before or after the fader.
  • Send the pre-fader signal when using on-stage floor monitors—this allows you to create a mix that is separate from the main mix.
  • Send the post-fader signal when using external effects processors or when you want to maintain the same mix balance as the main mix.
  1. Touch the ON or OFF button.
  • When turned ON, the signal is sent to the MIX channels.
  1. Touch the SEND PAN slider and adjust it with the [TOUCH AND TURN] knob.
  • When sending the signal to a stereo bus, adjust the send pan.
Related links