NETWORK (For Mixer Control) screen

The NETWORK (For Mixer Control) screen is for setting the network address needed for connecting a computer or iOS device via the NETWORK terminal of the DM3 series.

Set according to the computer and network to be connected.

NOTE
  • For how to connect to a LAN, refer to the DM3 Editor Installation Guide.

a

IP address acquisition method buttons

Select the method of acquiring an IP address.

  • DHCP :
  • Automatically acquires an IP address DHCP (Dynamic Host Configuration Protocol).
  • Static IP :
  • For setting the IP address yourself.

b

IP Address

Sets the address that identifies an individual device on the Internet or a LAN.

c

Subnet Mask

Defines how many bits of the IP address used in a network are used in the network address, which identifies the network.

d

Gateway

Within a network, this sets the address that identifies the device (gateway) that converts data of different media or protocols to each other.

e

PIN for MonitorMix

Sets the PIN (4-digit numeric password) to enter when connecting to the DM3 series console with the MonitorMix application.

MonitorMix is an application performers can use to adjust monitor balance from the stage.

f

Unit Name

Sets the name displayed in the network.

NOTE
  • When DHCP is selected as the IP address acquisition method, settings b to d are not necessary. If Static IP is selected, a screen opens for setting b to d. Enter the values for each item.
  • Set different subnets for For Mixer Control and For Device Control.