Error messages from YPAO
If any error message is displayed during the measurement, resolve the problem and perform YPAO again.
|
Error message |
Cause |
Remedy |
|---|---|---|
|
E-1:No Front SP (E-1:NO FRNT SP) |
Front speakers are not detected. |
Exit YPAO, turn off the unit, and then check the speaker connections. |
|
E-2:No Sur. SP (E-2:NO SUR SP) |
One of the surround speakers cannot be detected. | |
|
E-5:Noisy (E-5:NOISY) |
The noise is too loud. |
Keep the room quiet and retry YPAO. If you select “PROCEED”, YPAO takes the measurement again and ignores any noise detected. |
|
E-7:No MIC (E-7:NO MIC) |
The YPAO microphone has been removed. |
Connect the YPAO microphone to the YPAO MIC jack firmly and retry YPAO. |
|
E-8:No Signal (E-8:NO SIGNAL) |
The YPAO microphone cannot detect test tones. |
Connect the YPAO microphone to the YPAO MIC jack firmly and retry YPAO. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. |
|
E-9:User Cancel (E-9:CANCEL) |
The measurement has been canceled. |
Retry or exit YPAO as necessary. |
|
E-10:Internal Err. (E-10:INTERNAL) |
An internal error has occurred. |
Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. |
- Text in parentheses denotes indicators on the front display.
- To exit the YPAO measurement for resolving the problem, use the cursor keys to select “EXIT” and press ENTER.
- For the error messages E-5 and E-9 only, you can proceed with the current YPAO measurement. Press ENTER, and then use the cursor keys to select “PROCEED” and press ENTER.
- To retry the YPAO measurement from beginning, press ENTER, and then use the cursor keys to select “RETRY” and press ENTER.