Setting the initial volume for when the unit is turned on
Sets the initial volume when the unit is turned on.
Setup menu
“Sound” > “Volume” > “Initial Volume”
Settings
Off | Sets the level to the volume level of the unit when it last entered standby mode. | |
On | Mute | Sets the unit to mute the audio output. |
-80.0 dB to +16.5 dB (0.5 dB increments) [0.5 to 97.0 (0.5 increments)] | Sets the level to the specified volume level. |
NOTE
- This setting works only when the volume level is set lower than “Max Volume”. For details on “Max Volume” in the “Setup” menu, see the following:
- For details on the scale of the volume display (dB unit or numeric value), see the following:
Related links
- Checking the current audio signal information
- Enabling Lipsync adjustment
- Setting the adjustment method of the Lipsync function
- Adjusting the delay of the Lipsync function
- Selecting sound programs
- Adjusting the sound field effect level
- Adjusting the delay between the direct sound and presence sound field generation
- Adjusting the broadening effect of the presence sound field
- Adjusting the loss of the presence sound field
- Adjusting the decay time of the rear reverberant sound
- Adjusting the delay between the direct sound and reverberant sound generation
- Adjusting the volume of the reverberant sound
- Adjusting the delay between the direct sound and surround sound field generation
- Adjusting the broadening effect of the surround sound field
- Adjusting the loss of the surround sound field
- Adjusting the delay between the direct sound and surround back sound field generation
- Adjusting the broadening effect of the surround back sound field
- Adjusting the loss of the surround back sound field
- Selecting the surround decoder used in the program
- Setting the use of Center Spread
- Adjusting the center localization (broadening effect) of the front sound field
- Adjusting the entire volume for “7ch Stereo”
- Adjusting the front and rear volume balance for “7ch Stereo”
- Adjusting the left and right volume balance for “7ch Stereo”
- Adjusting the height volume balance using the presence speakers for “7ch Stereo”
- Setting the use of Monaural Mix for “7ch Stereo”
- Setting the dynamic range adjustment method
- Setting the limit value of the volume
- Adjusting the CINEMA DSP 3D effect level automatically
- Setting Virtual Surround Back Speaker (VSBS)