Setting Virtual Surround Back Speaker (VSBS)
Selects whether to create Virtual Surround Back Speaker (VSBS) using the surround speakers.
When VSBS is enabled, the unit creates VSBS when no surround back speakers are connected.
Setup menu
“Sound” > “Virtual Speaker” > “VSBS”
Settings
Off | Disables Virtual Surround Back Speaker (VSBS). |
On | Enables Virtual Surround Back Speaker (VSBS). |
NOTE
- VSBS is effective only when 6.1/7.1-channel content is played back.
- VSBS, that is working with CINEMA DSP 3D, is not available when the straight decode mode or the direct playback mode is enabled.
Related links
- Checking the current audio signal information
- Enabling Lipsync adjustment
- Setting the adjustment method of the Lipsync function
- Adjusting the delay of the Lipsync function
- Selecting sound programs
- Adjusting the sound field effect level
- Adjusting the delay between the direct sound and presence sound field generation
- Adjusting the broadening effect of the presence sound field
- Adjusting the loss of the presence sound field
- Adjusting the decay time of the rear reverberant sound
- Adjusting the delay between the direct sound and reverberant sound generation
- Adjusting the volume of the reverberant sound
- Adjusting the delay between the direct sound and surround sound field generation
- Adjusting the broadening effect of the surround sound field
- Adjusting the loss of the surround sound field
- Adjusting the delay between the direct sound and surround back sound field generation
- Adjusting the broadening effect of the surround back sound field
- Adjusting the loss of the surround back sound field
- Selecting the surround decoder used in the program
- Setting the use of Center Spread
- Adjusting the center localization (broadening effect) of the front sound field
- Adjusting the entire volume for “7ch Stereo”
- Adjusting the front and rear volume balance for “7ch Stereo”
- Adjusting the left and right volume balance for “7ch Stereo”
- Adjusting the height volume balance using the presence speakers for “7ch Stereo”
- Setting the use of Monaural Mix for “7ch Stereo”
- Setting the dynamic range adjustment method
- Setting the limit value of the volume
- Setting the initial volume for when the unit is turned on
- Adjusting the CINEMA DSP 3D effect level automatically