Automatically changing the input source names displayed on the front display
Automatically changes the input source names displayed on the front display. You can select a name created by the Auto Rename function.
Setup menu
“System” > “Input Rename”
Input sources
HDMI 1-5, AV 1, AUDIO 1-3
- Use the cursor keys to select an input source to be renamed.
- Use the cursor keys to select “Auto”.
- To change another input source name, repeat steps 1 to 2.
- Press SETUP.
- This completes the settings.
NOTE
When “Auto” is selected, the created name is saved even after the external device is disconnected. To reset to the default setting, switch the setting to “Manual” and then back to “Auto”.
Related links
- Checking the system information on the unit
- Setting the on-screen menu language
- Combining audio of another input source with video of the current input source
- Setting input sources to be skipped when operating the INPUT key
- Manually changing the input source names displayed on the front display
- Setting the use of Auto Play function
- Setting sound programs to skip when operating the PROGRAM key
- Setting the function for the PROGRAM key on the remote control
- Setting the unit's functions for the RED/GREEN/YELLOW/BLUE keys of the remote control
- Adjusting the brightness of the front display
- Setting the scale of the volume display
- Setting the use of short messages on the TV
- Setting the image to be used as wallpaper on the TV
- Specifying the condition for the TRIGGER OUT jack to function
- Specifying the output level of the electronic signal transmitted with each input
- Switching the output level for electronic signal transmission manually
- Specifying the zone with which the TRIGGER OUT jack functions are synchronized
- Setting the amount of time for the auto-standby function
- Setting the use of the eco mode
- Preventing accidental changes to the settings
- Updating the firmware via the network