Setting the function for the PROGRAM key on the remote control
Sets the function that is assigned to the PROGRAM key on the remote control. You can use the PROGRAM key for other than DSP program selection.
Setup menu
“System” > “Remote Key” > “PROGRAM Key”
Settings
Assign1 | Enables selecting the DSP Programs. |
Assign2 | Enables selecting just the DSP Movie/Music Programs. The up key of the PROGRAM keys: toggle between the Movie Programs The down key of the PROGRAM keys: toggle between the Music Programs |
Assign3 | Enables selecting the NETWORK sources. |
Assign4 | Enables moving to the previous/next page of the Browse Screen. |
Assign5 | Enables fine-adjusting the subwoofer volume. |
Assign6 | Enables adjusting the volume of dialogue sounds. |
Assign7 | Enables selecting shuffle/repeat settings. The up key of the PROGRAM keys: repeat The down key of the PROGRAM keys: shuffle |
Assign8 | Displays the front/on-screen display information. The up key of the PROGRAM keys: front display information The down key of the PROGRAM keys: on-screen display information |
- Checking the system information on the unit
- Setting the on-screen menu language
- Combining audio of another input source with video of the current input source
- Setting input sources to be skipped when operating the INPUT key
- Automatically changing the input source names displayed on the front display
- Manually changing the input source names displayed on the front display
- Setting the use of Auto Play function
- Setting sound programs to skip when operating the PROGRAM key
- Setting the unit's functions for the RED/GREEN/YELLOW/BLUE keys of the remote control
- Adjusting the brightness of the front display
- Setting the scale of the volume display
- Setting the use of short messages on the TV
- Setting the image to be used as wallpaper on the TV
- Specifying the condition for the TRIGGER OUT jack to function
- Specifying the output level of the electronic signal transmitted with each input
- Switching the output level for electronic signal transmission manually
- Specifying the zone with which the TRIGGER OUT jack functions are synchronized
- Setting the amount of time for the auto-standby function
- Setting the use of the eco mode
- Preventing accidental changes to the settings
- Updating the firmware via the network