Setting the use of the video signal processing
Enables/disables the video signal processing (resolution and aspect ratio).
Setup menu
“Video/HDMI” > “Video Mode” > “Video Mode”
Settings
Direct | Disables the video signal processing. |
Processing | Enables the video signal processing. Configure the settings in “Resolution” and “Aspect”. |
NOTE
- When “Video Mode” is set to “Direct”, the unit transmits video signals with the least circuitry in order to reduce video output delay.
- When “Video Mode” is set to “Processing” and the resolution is being converted, short messages are not displayed on the TV screen.
Related links
- Checking the current video and HDMI signal information
- Setting a resolution to output HDMI video signals
- Setting an aspect ratio to output HDMI video signals
- Setting the use of HDMI Control
- Setting the audio jack used for TV audio input
- Setting the use of ARC
- Linking the standby modes of the unit and the TV
- Setting the output of HDMI audio from the TV speaker
- Setting the version of HDCP used on the HDMI input jacks
- Setting the use of HDMI Standby Through