Loading a File from a USB Drive

Follow the steps below to load the setting file from the USB drive into the console. You can use the same procedure to load the following files other than the setting file.

Extension

Contents of file

.dm7f

All data including internal settings

.BMP

Image file for display in the CONSOLE LOCK screen (256 or more colors, uncompressed bitmap format)

.jpg

Image file for display in the CONSOLE LOCK screen (JPEG format)

.png

Image file for display in the CONSOLE LOCK screen (PNG format)

NOTICE
  • Some data may contain settings that will cause the console to output signals immediately after the data is loaded. Therefore, before loading data, turn off the power to the connected equipment and/or lower the volume of such equipment so that there will not be a problem even if a signal is output.
  1. Press the Save/Load button in the Utility screen to access the Save/Load popup window.
  • Select a file to load.
NOTE
  • The Load button will become available if you select loadable data.
  1. Press the Load button.
  • The LOAD screen will appear, in which you can select data to load.
  1. In the LOAD screen, select a type of data and data to load.
  1. Press the Load button. A confirmation dialog box will appear.
  1. Press the OK button to begin loading the data.
  • When the file has finished loading, the PROCESSING window that shows the progress of the loading operation will close.
NOTE
  • Setting files that have been saved in Split mode can only be loaded on consoles in Split mode that have the same Mix bus configuration.
Related links
  • --- リンクがありません ---