Delay Plug-ins

MonoDelay

This is a mono delay effect. The delay line uses either tempo-based or freely specified delay time settings.

LO FILTER: Affects the feedback loop of the effect signal and allows you to roll off low frequencies. The button below the knob activates/deactivates the filter.
HI FILTER: Affects the feedback loop of the effect signal and allows you to roll off high frequencies. The button below the knob activates/deactivates the filter.
DELAY: Sets the delay time in milliseconds.
SYNC: Activates/Deactivates tempo sync.
FEEDBACK: Sets the amount of the signal that is sent back into the delay input. The higher this value, the higher the number of repeats.
MIX: Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.

PingPongDelay

This is a stereo delay effect that alternates each delay repeat between the left and right channels. The delay line uses either tempo-based or freely specified delay time settings.

This plug-in works only on stereo racks.

LO FILTER: Affects the feedback loop of the effect signal and allows you to roll off low frequencies. The button below the knob activates/deactivates the filter.
HI FILTER: Affects the feedback loop of the effect signal and allows you to roll off high frequencies. The button below the knob activates/deactivates the filter.
DELAY: Sets the delay time in milliseconds.
SYNC: Activates/Deactivates tempo sync.
FEEDBACK: Sets the amount of the signal that is sent back into the delay input. The higher this value, the higher the number of repeats.
MIX: Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.
SPATIAL: Sets the stereo width for the left/right repeats. Turn clockwise for a more pronounced stereo ping-pong effect.
START LEFT/START RIGHT: Determines whether the delay repeat starts on the left or the right channel.

StereoDelay

This is a stereo delay effect that includes two independent delay effects. It can either be tempo-based or use freely specified delay time settings.

This plug-in works only on stereo racks.

FEEDBACK: Sets the number of repeats for each delay.
DELAY: Sets the delay time in milliseconds.
SYNC: Activates/Deactivates tempo sync for the corresponding delay.
MIX: Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.
LO FILTER: Affects the feedback loop of the effect signal and allows you to roll off low frequencies. The button below the knob activates/deactivates the filter.
PAN: Sets the stereo position.
HI FILTER: Affects the feedback loop of the effect signal and allows you to roll off high frequencies. The button below the knob activates/deactivates the filter.