Modulation Plug-ins

Sets the number of voices. Each voice has a [Detune] and a [Delay] slider.

Sets the relative amount of detune for each voice. Positive and negative values can be set. If set to zero, no detune takes place for that voice.

Sets the relative delay amount for each voice. If set to zero, no delay takes place for that voice.

Sets the overall amount of detune for all voices. If set to zero, no detune takes place regardless of the [Detune] slider settings.

Changes the pitch algorithm that is used for detune.

Sets the amount of detune variation if [Static Detune] is deactivated. With [Humanize], the detune is continuously modulated for a more natural effect.

Activate this button to use a static amount of detune.

Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.

Spreads the voices across the stereo spectrum. Turn the control clockwise for a deeper stereo effect.

Sets the output gain.

Governs the overall depth of the delay for all voices. If set to zero, no delay takes place regardless of the [Delay] slider settings.

Controls the amount of delay variation if [Static Delay] is deactivated. With [Humanize], the delay is continuously modulated for a more natural effect.

Activate this button to use a static delay amount.

Allows you to control the speed of the rotary speaker.

If the [Set Speed Change Mode] setting is set to the right, this knob allows you to modulate the rotary speed.

If this is set to the left, the speed selector settings are taken into account. If this is set to the right, you can modulate the speed with the [Speed Mod] knob.

Applies a soft overdrive or distortion.

Sets the crossover frequency (200 to 3000 Hz) between the low and high frequency loudspeakers.

Allows for a fine adjustment of the high rotor [slow] speed.

Allows for a fine adjustment of the high rotor [fast] speed.

Allows for a fine adjustment of the high rotor acceleration time.

Controls the high rotor amplitude modulation.

Controls the high rotor frequency modulation.

Allows for a fine adjustment of the low rotor [slow] speed.

Allows for a fine adjustment of the low rotor [fast] speed.

Allows for a fine adjustment of the low rotor acceleration time.

Adjusts the modulation depth of the amplitude.

Adjusts the overall bass level.

Adjusts the phasing amount in the sound of the high rotor.

Sets the simulated microphone angle. A value of 0 ° corresponds to a mono miking setup with a single microphone in front of the speaker cabinet, 180 ° corresponds to a stereo miking setup with a microphone on each side of the cabinet.

Sets the simulated microphone distance from the speaker in inches.

Sets the output level.

Sets the level balance between the dry signal and the wet signal.

Affects the frequency range of the modulation sweep by adjusting the initial delay time.

Sets the depth of the chorus effect. Higher settings produce a more pronounced effect.

Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.

Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.

If [Tempo Sync] is activated, [Rate] allows you to specify the base note value for synchronizing the modulation sweep to the tempo of the host application (1/1 to 1/32, straight, triplet, or dotted).
If [Tempo Sync] is deactivated, the sweep rate can be set freely with the [Rate] dial.

Activates/Deactivates tempo sync.

Allows you to select the modulation waveform, altering the character of the chorus sweep. A sine and a triangle waveform are available.

Allows you to roll off low and high frequencies of the effect signal.