Connecting speakers

Use speaker cable (commercially available) to connect speakers to the product.

NOTE
  • Use the speakers with an impedance of at least 4-ohm.
  • When connecting 2 sets of speakers (Speaker A and Speaker B), use the speakers with an impedance of at least 8-ohm.
  • When connecting 4-ohm (4-ohm or more but less than 8-ohm) speakers, change the speaker impedance on the Advanced Setup menu.
  1. Peel off about 10 mm of insulation on the end of the speaker cable and twist its core tightly.
  1. Turn the knob of the speaker jack to the left to loosen it, then insert the core of the speaker cable into the hole in the jack.
  1. Turn the knob back to the right to tighten it.
NOTICE
  • When preparing the speaker cable, do so far away from the product. Pieces of the core wires of the speaker cable may fall inside the product and cause a short circuit, resulting in malfunction.
  • Do not allow the core wires of a speaker cable to touch the core wires of another speaker cable or any metal parts of the product. Doing so may damage the product and/or the speakers.
NOTE
  • Be sure to connect to the jacks correctly: left channel (L), right channel (R) and + (red), - (black). If connected incorrectly, no audio may be output from the speakers. Also, if the polarity is wrong, the audio may sound strange.

Connecting via banana plug (Models for U.S.A., Canada, Australia, Taiwan and for Central and South America)

When using a banana plug, tighten the knob of the speaker jack and insert a banana plug into the end of the jack.

Related links