11. Mixer Mode

Hold down the [ALL] knob and press the [VOL+] button to switch to Mixer mode. Use the same procedure to exit Mixer mode.

When you switch to Mixer mode, [MIXER] lights up on the index.

Press Sound Design knobs 1–4 to select the sound parameters to be adjusted. The sound parameters correspond to Sound Design knobs 1–4. From the top, they are set to PAN, VOLUME, REVERB SEND, and DELAY SEND. The index of the selected parameter lights up.

Turn the Track knobs to adjust the sound parameters for each track. The LED lamps on the Track knobs and the Global Meter indicate the value. You can also press and turn the Track knobs to make greater changes to the sound parameters.

Turning the [ALL] knob adjusts the PAN of the entire project, the VOLUME of the entire project, the RETURN LEVEL of the send effect REVERB, and the RETURN LEVEL of the send effect DELAY for the currently selected parameter.

11.3.1 Changing the type of send effect (REVERB, DELAY SEND)

Eight presets are provided for both REVERB and DELAY. When adjusting REVERB SEND or DELAY SEND, turn the [FX] knob to change the preset. The preset number is displayed on the Global Meter. For a list of presets, see “17.6 SEND EFFECT Presets.”

11.3.2 Adjusting send effect (REVERB, DELAY) parameters

Slide the [FX LEVEL]/[HIGH PASS]/[REPEATER] touch sliders to adjust the parameters. Different send effect parameters for adjusting are assigned to each page. To switch pages, press the FX Page button.

11.3.3 Send effect (REVERB, DELAY) parameters

11.3.4 Example: Send effect parameters for preset No. 1 [HD Room] in REVERB

NOTE

・   For a list of presets, see “17.6 SEND EFFECT Presets.”