[55–62] Utility
Menu 55–62 lets you make other useful settings. After using the 
buttons to select an item, the Voice Guide announces the item name by starting from the number then “Utility.”
[55–56] Sound Output
No. | Item name (Voice Guide) | Description | Range | Default Value |
55 | Utility Speaker EQ/Compressor Type | Standard This is the standard setting. Heavy This setting emphasizes low frequencies. It creates a very powerful sound. Bright This setting emphasizes high frequencies. It creates a very bright sound. Mild This setting attenuates high frequencies. It creates a gentle listening experience. Powerful This setting uses a strong compressor. It creates a sense of sound pressure. | Standard, Heavy, Bright, Mild, Powerful | Standard |
56 | Determines whether to output audio from the built-in speaker. Off Audio is not output from the built-in speaker, regardless of whether or not an external audio device is connected to the [PHONE/OUTPUT] jack. Headphone Switch Audio is not output from the built-in speaker when an external audio device is connected to the [PHONES/OUTPUT] jack, and audio is output from the built-in speaker when an external audio device is not connected to the [PHONES/OUTPUT] jack. On Audio is output from the built-in speaker, regardless of whether or not an external audio device is connected to the [PHONE/OUTPUT] jack. | Off, Headphone Switch, On | Headphone Switch |
@
[57–58] USB Audio
No. | Item name (Voice Guide) | Description | Range | Default Value |
57 | Determines whether the audio signal input via the [USB TO HOST] terminal is sent back to the connected device again ("On") or not ("Off"). When set to "On," an Audio Loopback (audio sent from an external device to this product is returned to the external device) is configured by connecting the [USB TO HOST] terminal to an external device such as a computer or smart device via USB. This allows you to mix music from an external device with your performance on this product and record that mix to a DAW. | Off, On | On | |
58 | Utility USB Audio Output Gain | Determines the amount of volume amplification when outputting audio to an external device connected via USB. A positive value increases the volume while a negative value decreases the volume. | −18, −12, −6, 0, +6, +12, +18 | 0 dB |
@
Loop connection
Noise might be generated when a single computer or smart device is connected to both the [AUX IN] jack and the [USB TO HOST] terminal (loop connection). If this occurs, try the following troubleshooting steps.
• Disconnect the cable from the [AUX IN] jack and use only the USB cable for audio communication.
• If you are using a USB cable to charge this product, be sure to connect it to a USB adapter or other power source instead of a computer or smart device.
[59–62] Other settings
No. | Item name (Voice Guide) | Description | Range | Default Value |
59 | Inverts the Pad numbers between the left and right sides of the product. "Left" is for playing primarily with your left hand while "Right" is for playing primarily with your right hand. | Left, Right | Right | |
60 | Determines the Velocity of the audition sound that is played back when the Pad sound (Voice) is changed in " | Off, 1–127 | 100 | |
61 | Determines whether the Pad controls the internal tone generator (ON) or not (OFF). If you are using only an external MIDI tone generator connected via USB, set this item to "Off." | Off, On | On | |
62 | To prevent unnecessary power consumption, the power is automatically turned off after a certain period of inactivity. This lets you set the time that elapses before the power is automatically turned off. See this page for details. | Disabled, 5, 10, 15, 30, 60, 120 minutes | 30 minutes |
Menu 23
Menu 24 @