9. Changing the Mute Setting at Start Up

When you first start up and use this product after purchasing it, the inputs and outputs will be muted until the unit receives HA parameter settings.

note NOTE

The message “SYNCHRONIZING WITH CONSOLE OR CONTROLLER” appears on the screen (see “ SYNC messages ”). In addition, the MUTE icon ( icon mute ) appears on the home screen.

This is because START UP mode is set to REFRESH with MUTE by default.

Disp START UP

You can change the mute setting at start up in START UP mode.

1. While the MENU TOP screen is displayed, turn the encoder with switch to select SETUP, and then press it to confirm.

2. In the SETUP menu, turn the encoder with switch to select START UP (START UP mode), and then press it to confirm.

3. Turn the encoder with switch to select REFRESH with MUTE, RESUME w/o MUTE, or REFRESH w/o MUTE.

9.1. REFRESH with MUTE (Initial Setting)

The unit starts up with the initialized HA parameters. The inputs and outputs will be muted until the unit receives HA parameter settings from the supported device.

note NOTE

To control the HA parameters from the supported device, select this option to prevent inadvertently outputting unmuted audio until the settings are received.

9.2. RESUME w/o MUTE

The unit starts up in the state it was in prior to the most recent power-off. The inputs and outputs will not be muted.

9.3. REFRESH w/o MUTE

The unit starts up with the initialized HA parameters. The initial values are the same as for REFRESH with MUTE. However, the inputs and outputs will not be muted.

Related link(s)
“ SETUP menu ”