Power supply

Connecting the power supply

caution Warning

  • Always use the power cords included with this device. Do not use the included power cords for other devices. Otherwise, failure, overheating or fire may occur. The included power cords are only for use in Japan (up to 125 V).

caution Caution

  • Be sure to switch off this device before connecting or disconnecting a power cord.

  1. Connect the included power cords. Connect the power cord to this device, and then plug it into an electrical outlet.

note NOTE

  • To disconnect a power cord, reverse the above procedure.

  • Press the power plug latch when disconnecting the power cord.

Switching on/off this device

  1. Switch this device on ( I )/off ( stanby )with the power switch on its rear panel.

power on

important Notice

  • Before switching this device on again after switching it off, wait at least six seconds. Otherwise, a failure may occur.

  • A small amount of current is flowing, even when this device is switched off. Before extended periods of disuse, be sure to disconnect the power cords from the electrical outlets.