Dante Settings

This specifies settings related to the Dante network.

dante setting c
6 dante settings s

note NOTE

  • Settings in Dante Controller are changed in sync with the parameters in this [Dante Settings] screen.

Specifying the sampling frequency (Sample Rate)

This allows you to specify the Dante input/output sampling frequency. Select from [44.1 kHz], [48 kHz], [88.2 kHz], and [96 kHz].

sample rate

Specifying the preferred leader (Preferred Leader)

Selecting [On] sets this device to be “Preferred Leader” (device supplying the master clock).
If more than one device is set to be “Preferred Leader”, the device with the lowest MAC address will be used.

preferred leader

Specifying the encoding (Encoding)

This allows you to specify the Encording (number of quantization bits). Select from [24 bit] or [32 bit].

encording

Specifying the latency (Latency)

This allows you to specify the latency for signals sent and received over a Dante network.
Select from [0.25 ms], [0.5 ms], [1 ms], [2 ms], and [5 ms].
The appropriate latency setting for signals sent and received over a Dante network differs depending on the connection method and scale.

latency

Specifying the secondary port (Secondary Port)

Select [Redundant] or [Daisy Chain] for the connection method for the two Dante ports.
After the setting is changed, a message appears, prompting you to restart this device.

secondary port

note NOTE

  • The setting is applied after this device is restarted.